Product Description:

The Allen-Bradley 1756-DHRIO is a ControlLogix Data Highway Plus/Remote I/O communication interface module. This module has Two (2) channels, supporting communication rates of 57.6 kilobytes per second, 115.2 kilobytes per second, and 230.4 kilobytes per second, depending on the cable length. It can transfer a message through a maximum of three chassis and four communication networks. With this module, information exchange can be done among devices such as PLCs, SLCs, and ControlLogix controllers, even on different networks.

It supports the following types of communication: Remote I/O, Control and Information Protocol (CIP) Messaging, and Data Highway Plus (DH+) Messaging between devices. It can have up to 32 Logix connections and the remote I/O link can connect to a remote I/O device, as well as other intelligent devices. When connected to a remote I/O network, it can act as an adapter or scanner and transfer analog, digital, block, and specialty data even with the absence of message instructions. Prior to installing the 1756-DHRIO module, you need to program the network type switches for each channel and install and connect a ControlLogix power supply and chassis. You can install as many modules as you can in the same chassis but this will depend on your available power supply. Note that modules can also be installed or removed even when the chassis power is applied but you need to observe safety precautions, particularly that the area is nonhazardous and power is removed, to prevent an electrical arc that can cause excessive wear to the contacts of both the module and the connector. Make sure to discharge potential static because the module is sensitive to electrostatic discharge.

RIO and DH+ protocol uses the same cable type. Recommended cables are Belden 89463 twinaxial, 0.52 mm² (20 AWG) rated at 200 °C (392 °F). Applicable spare connector is Phoenix terminal with part number MVSTBR2.5/3-ST BK AU.

DH+ and Remote I/O network requires the use of a terminating resistor as it follows daisy-chain topology. This resistor is installed at the first and last node of the network. Resistor values depend on the network speed. 82 Ohms is used for network speed of 230.4Kbps. 150 Ohms is used for network speed of 57.6 Kbps or 115.2 Kbps. Other considerations are also considered including the type of devices connected to the network. The terminating resistor is installed across line 1 and line 2 of the cable. The 3rd cable is the shield cable.

To terminate the cable following RIO protocol, Line 1 is connected to the bottom pin or terminal 1, shield cable is terminated to the middle pin and Line 2 is terminated to the last pin. To wire the cable appropriately as DH+ protocol, simply reverse the connection of Line 1 and Line 2.

This module supports communication with Flex IO, POINT IO systems and messaging functions with PLC 5, SLC, CompactLogix and ControlLogix controllers as well.

Guizhou Yuanmiao focuses on DCS, PLC, robot and large-scale servo systems.

Main products all kinds of modules/cards, controller, touch screen, servo drive

Advantages of the company: the supply of imported authentic products, professional discontinued parts

Fast delivery, accurate delivery, primary source, spot inventory more than 100 million

Our main control system (DCS, PLC/SPS, CNC), panel controller, HMI and display panel, industrial PC, drive (inverter and servo system), motor, power supply

Allen-bradley :ControlLogix 1756 series controller, CompactLogix 1769 Series controller, SLC 500 1747 1746 series controller, PLC-5 1771 1785 series controller, ProSoft:mvi 69/PS69/mvi 56/mvi 94/mvi 71/mvi 46/3150, ICS TRIPLEX trusted system

ABB:AC800M series controller I/O module, AC800F series controller module, AC31 series controller module, 800xA series module, Bailey INFI 90 module, DSQC robot module spare parts, Advant OCS system spare parts, H&B Freelance module Enquiry contact Zeng Manager :15339537573

Bentley Nevada :Bently 3500 monitoring system, Bently 3300 monitoring system, preprocessor, eddy current sensor probe

Schneider :Quantum 140 series :Modicon M340, Modicon Premium :CPU processor module, communication module, etc

Emerson :Ovation system DCS card, DeltaV system double channel redundant security system, redundant controller General Electric :IS200/DS200 series excitation system card, IC 693/IC 695/IC 697/IC 698/IC 200/IC 660/IC 670 CPU module, communication module, analog and digital module

Invensys Triconex Card: Redundant fault-tolerant control system, modern fault-tolerant controller based on Triple module redundancy (TMR) architecture.

Invensys Foxboro :FBM(field input/output module) sequence control, ladder logic control, accident recall processing, digital/analog conversion, input/output signal processing, data communication

Honeywell :Alcont, Experion LS, Experion PKS, Experion HS, Plant Scape, TDC 2000, TDC3000, TPS

Yokogawa :CS3000 system CPU inquiry contact Zeng manager: 15339537573

Order please contact us:

Contact :15339537573(same wechat number)

QQ; 2054523139

Mail box; 2054523139@qq.COM

Note; All the products on this site are special products, the market price has been fluctuating, the specific customer service quotation shall prevail, the product models are many, can not be uploaded one by one, if there is not found the model, can contact customer service at any time. Store product price, not real price, before bidding please contact customer service for accurate price and delivery time, sorry for the inconvenience to you!

We will let time prove that your choice is not wrong! We will use sincere service in exchange for your 200% satisfactionHigh quality low price spot to provide your satisfaction is our goal for effortsCooperative customers, before ordering can provide the qualification and the recent sales issued the scanning copy of the bill for inquiry.After-sales problems: Execute according to the brand manufacturer's standard, guarantee after-sales service, one-year warranty for all products, etc

【 Disclaimer 】

Guizhou Yuanmiao Automation Equipment Co., LTD. We sell new products and discontinued products, independent channels to purchase such special products. Guizhou Yuanmiao Automation Equipment Co., Ltd. is not an authorized distributor, distributor or representative of the featured products on this website. All product names/product images, trademarks, brands and logos used on this website are the property of their respective owners. Descriptions, descriptions or sales of products bearing these names, images, trademarks, brands and logos are for identification purposes only and do not imply any association or authorization with any rights holder